Photos by Jeff Hamilton, EAA 898

March 2023

Bob N and Mike move a side piece of the RV 10.jpg
Bob N and Mike provide support while Walt N sets a rivet on the RV 10 tail support.jpg
Bob N and Mike work on adding supports to a RV 10 horizontal stabilizer.jpg
Bob N and Walt N rivet a RV 10 bulkhead.jpg
Bob N and Walt N rivet a RV 10 part.jpg
Bob n and Walt N work on riveting RV 10 tail supports.jpg
Bob N looks on as Mike sets a cleco in. the RV 10 tail while Walt N holds a bulkhead in place.jpg
Bob N polishes a part for the RV 10.jpg
Dave and Doug work on a RV 10 horizontal stabilizer.jpg
Dave drills rivet holes in a RV 10 horizontal stabilizer.jpg
Dave drills rivet holes into RV 10 tail section supports.jpg
Dave stands by with the supports while Mike and Bob N ready the RV 10 tail section to be riveted onto the supports.jpg
Debbie roughs a RV 10 part for painting while Bill smooths a piece of CX 4 angle iron in the background.jpg
Glen applies primer coats to RV 10 parts.jpg
Kurt works on a Cub weathervane while Debbie works on a RV 10 support.jpg
Mike and Dave drill rivet holes and set clecos in the RV 10 tail section.jpg
Mike and Dave test fit a RV 10 bulkhead onto the supported tail portion.jpg
Mike Dave and Bob N work on supporting a RV 10 horizontal stabilizer.jpg
Mike Gene and Bob N dismantle the RV 10 tail bulkheads in order to work on them.jpg
Mike places clecos after Dave drills the rivet hole in a RV 10 horizontal stabilizer.jpg
RV 10 tail bulkheads set in place before painting.jpg
RV 10 tail section ready to add supports.jpg
Walt N Bob N and Mike work on RV 10 tail supports.jpg
Walt N looks on as Mike removes tape from the RV 10 tail section.jpg
Walt N moves a RV 10 bulkhead into place for measuring as Mike sets clecos.jpg
Previous

April 2023
Next

February 2023